Teledyne-lecroy Serial Data Debug Solutions Manual do Utilizador descarregar pdf (Página 153)

Operator's Manual

919586 RevA

153

 Touch the CDR control and select from Linear, Filtered, and Short-Term choices.

 The next two controls allow you to either enter a specific Bit Rate, or have MIPI M-PHY find your signal's

bitrate.

 Finally a convenient SDA Menu... button is available for quick access to the main SDA dialog.

THE VIEWS DIALOG (INCLUDING THE SHOW EYE CONTROL)

Touch the Views tab and the Views dialog is shown.

Note: Some of the controls on this dialog are enabled/disabled based on Mode, Probing, and Input Selection

control choices.

This dialog includes controls for Data Diff, Eye, Mask Mode, CDR, Common-mode, PSD, CM Load, Fall, and Rise.

As controls are used, MIPI M-PHY processes the information and responds in real time.

The Show Eye Control

Marking this checkbox shows the eye diagram trace on the display area and includes a corresponding trace

descriptor label.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 203 204

Sem comentários

Teledyne-lecroy Serial Data Debug Solutions Manual do Utilizador Página 153