Teledyne-lecroy Serial Data Debug Solutions Manual do Utilizador descarregar pdf (Página 136)

Serial Data Debug Solutions

136

919586 RevA

Go directly to its corresponding test dialog and enable/disable it from there. Additional controls for Measure

On, Burst Index, and Actions for Dphy1 buttons are made available from the specific test dialog.

LP (LOW POWER) TESTS

All Dphy1 - X dialogs have controls for On, Category, Measure On, Measure and Actions for Dphy1 buttons.

When the LP Rise & Fall category is selected, Dn-VOH, Dn-VOL, and Find Levels controls are also shown.

With LP (Low Power) selected as your Mode on the Mode and Input Selection Area of the MIPI D-PHY Dialog

(on page 135), Categories and Measurements on the Dphy1 - X dialogs vary in the following manner.

Note: For HS (High Speed) Tests, refer to the HS (High Speed) Tests (on page 139) topic.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 203 204

Sem comentários

Teledyne-lecroy Serial Data Debug Solutions Manual do Utilizador Página 136