Teledyne-lecroy QPHY-DisplayPort Manual do Utilizador descarregar pdf (Página 10)

QPHY-DisplayPort-OM-E Rev A

QualiPHY tests the oscilloscope connection after clicking the Start button. The system prompts you if there is a

connection problem. QualiPHY’s Scope Selector function can also be used to verify the connection. Please refer

to the QualiPHY Operator’s Manual for explanations on how to use Scope Selector and other QualiPHY

functions.

Accessing the QPHY-DisplayPort Software using QualiPHY

This topic provides a basic overview of QualiPHY’s capabilities. Please refer to the QualiPHY Operator’s Manual

for detailed information.

Access the QPHY-DisplayPort software using the following steps:

1. Wait for the oscilloscope to start and have its main application running.

2. Launch QualiPHY from the Analysis menu if installed on the oscilloscope or from the desktop icon if installed

on a host computer.

3. From the QualiPHY main window (as follows), select Standard, then DPORT from the pop-up menu (if not

already selected). If you check the Pause on Failure box (circled) QualiPHY prompts to retry the measure

whenever a test fails.

Figure 3. QualiPHY main menu and compliance test Standard selection menu

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Sem comentários

Teledyne-lecroy QPHY-DisplayPort Manual do Utilizador Página 10