Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manual do Utilizador descarregar pdf (Página 32)

CANbus Trigger, Decode, and Measure

CANbus-TD-TDM-OM-E RevB

For instance, take the example below of an analog signal creating a burst of CAN messages.

This data was acquired over a 500 ms duration. It is likely that you want to understand whether

the analog signal input to your electronic control unit (ECU) is creating the desired CAN message

output from the ECU. There are a number of ways that this could be done.

Using Cursors

Use horizontal cursors to mark locations on the waveform where the time measurement should

be done, then read the cursor values to establish the measurement. As necessary, adjust the

timebase or create zooms of the channels and the CAN Trace to view the signal with enough

detail. This is a good method for single-shot / single measurements.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 68 69

Sem comentários

Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manual do Utilizador Página 32